Metlab SDSU Equipment
Olympus OmniScan MX
This system includes the phased array and eddy current array modules which can be used for surface and subsurface flaw detection and characterization in materials. This unit offers a high acquisition rate and powerful software to efficiently perform manual and automated inspections.

METLAB uses this machine for both research and testing for our clients. Contact us to discuss your project by email: METLAB@sdstate.edu or phone: 605-688-4300
Test Space
Phased Array Module
    Connector: OmniScan connector for phased array probe, 2 BNC (1 pulser/receiver and 1 receiver for conventional UT)
    Focal Laws: 256
    Pulser Voltage: 80 V per element
    Pulse Width: Adjustable from 30 ns to 500ns, resolution of 2.5 ns
    Pulser Fall Time: Less than 10 ns
    Pulse Shape: Negative square wave
    PulserOutput Impedance: Less than 25
    Receiver Gain: 0 dB up to 74 dB, maximum input signal 1.32 Vp-p
    Receiver Input Impedance: 75
    Receiver System Bandwidth: 0.75 MHz to 18 MHz (-3 dB)

Eddy Current Array
    Connectors: 1 OmniScan for eddy current array probe, 1 19-pin Fischer eddy current probe, 1 BNC connector
    Number of Generators: 1 (with internal electronic reference)
    Maximum Generator Voltage: 12 Vp-p
    Generator Operating Frequency: 20 Hz to 60 MHz
    Generator Bandwidth: 8 Hz to 5 KHz
    Number of Receivers: 1 to 4
    Maximum Receiver Input Signal: 1 Vp-p
    Receiver Gain: 28 dB to 68 dB
Key Features :
  • Modular instrument allowing the instrument to be switched to different inspection modules
    
  • Probe ID connector enables physical detection and recognition of probes connected to the instrument
Manufacturer's Website :
Latest Your Comments :

Please Wait ...

Add new comment Hide Form

Copyright © 2013 The Materials Evaluation and Testing Laboratory at South Dakota State University